| Brake calliper to wheel carrier |
M12 x 1.5/always use new screws following removal |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| EPB cable holder to wheel carrier |
M6 screw |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Drive shaft to wheel hub (setting 1) |
Setting 1: Before installing the wheel carrier, M22 x 1.5 thread |
Tightening torque |
130 Nm (96 ftlb.) |
|
|
| Drive shaft to wheel hub (setting 2) |
Setting 2: With wheel carrier installed, M22 x 1.5 thread |
Tightening torque |
460 Nm (340 ftlb.) |
|
|
| Tie rod to wheel carrier |
M12 x 1.5 x 70 thread |
Tightening torque |
50 Nm (37 ftlb.) |
+60° |
|
| Upper control arm (front and rear) to wheel carrier |
M12 x 1.5 thread |
Tightening torque |
50 Nm (37 ftlb.) |
+60° |
|