Technical Values

Location	Description	Type	Basic value	Tolerance 1
Pressure line to valve block	M14 x 1.5 thread	Tightening torque	28 Nm (21 ftlb.)
Subframe to front body	M12 x 1.5 x 75 thread	Tightening torque	90 Nm (67 ftlb.)	+90°
Subframe to rear body	M12 x 1.5 x 75 thread	Tightening torque	90 Nm (67 ftlb.)	+90°
Engine mount to subframe	M10 x 80 thread	Tightening torque	65 Nm (48 ftlb.)
Brake calliper to wheel carrier	M14 x 1.5 thread (always replace screws and lock nuts after removal.)	Tightening torque	140 Nm (104 ftlb.)
Upper wishbone to tapered end of wheel carrier	M12 x 1.5 thread	Tightening torque	85 Nm (63 ftlb.)
4 Front - Support for front axle and crash support to body	M12 x 1.5 x 130 thread	Tightening torque	90 Nm (67 ftlb.)	+180°
4 Rear - Vibration strut (transverse strut) with support for front axle to body	M12 x 1.5 x 58 thread	Tightening torque	90 Nm (67 ftlb.)	+90°
Support for front of front axle to subframe	M8 x 20 thread	Tightening torque	33 Nm (24 ftlb.)
Drive shaft to differential	M8 x 53 thread	Tightening torque	22 Nm (16 ftlb.)	+90°
Lower wishbone to spring strut	M12 x 1.5 thread	Tightening torque	90 Nm (67 ftlb.)	+120°
Steering spoiler (air guide) to lower wishbone with take-up hole	M6 x 50 thread	Tightening torque	10 Nm (7.5 ftlb.)
Universal joint to steering gear	M8 x 30 thread	Tightening torque	20 Nm (15 ftlb.)	+90°
Heat shield to steering gear	M6 x 12 thread	Tightening torque	10 Nm (7.5 ftlb.)