Removing Roof Console
Information
- The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment.
- The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant.
- Some steps must be carried out automatically.
- Some of the repair illustrations show only one side of the vehicle.
- Switch off ignition and remove remote control (hand-held transmitter).
- Unclip cover for headliner.
- Unclip headliner at the two side cut-outs -A- and swivel it downwards -B- .
- Lift headliner off towards the rear.
- Disconnect wire harness.
- 5.1. Release plug connections -a- and disconnect them -B- .
- 5.2. Unclip fixing clip for wire harness using disassembly tool Nr.21 (-C- ).