Installing Spray Nozzle For Headlight Cleaning System

Information 

If the lifting cylinder was dropped or the spring-loaded, extended headlight washer system was released abruptly while removing and installing the spray nozzle, the component must be replaced with a new one.

1. Insert lifting cylinder -1-  in an upward direction and clip it into the retaining frame.
   Fig 1: Installing Lifting Cylinder

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Slide hose onto the spray nozzle and clip it in.
   Fig 2: Sliding Spray Nozzle Hose And Clip

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Clip hose into the lifting cylinder bracket.
4. Clip cap for front apron onto the nozzle head (individual part).
5. Push spray nozzle and cap -1-  into the lifting cylinder from above -A-  until the cap is flush with the front apron.
   Fig 3: Installing Spray Nozzle

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. Check that the cap is fitted correctly in the hole on the front apron. If the cap is not fitted securely enough, the nozzle head can be pressed in slightly. One detent = 1.25 mm.