Removing Cover For Front Seat
- Use a plastic wedge to carefully detach the cover from the rear seat frame -arrows- .
- Disconnect plug connections -1-
for heated seats -arrows-
.
Only for heated seats.
- Detach the cover -1- using a plastic wedge and pull it out all the way around -arrow- .
- For heated seats with seat-surface extension:
- 4.1. Disengage cover for seat extension from underneath all the way around -arrows- .
- 4.2. Pull off connector for seat heating -1- for seat-surface extension under the seat -A- .
- 4.3. Cut all tie-wraps used to secure the seat heating line for the seat-surface extension using side cutters.
- 4.4. Cut tie-wraps -1- and pull seat heating line for seat-surface extension through towards the front -A- .
- 4.5. Pull the cover -1- over the cushion -2- and disengage the restraining straps -3- on both sides by pulling them outwards -A- .
- Loosen cushion clips on the cushion carrier.
- 5.1. For seats with air conditioning:
Disengage cushion clips -1- at the cushion carrier -2- (-A- ).
- 5.1.1. Disengage cushion clips -1- at the sides.
- 5.2. For seats without air conditioning:
Cut cushion clips -1- at the cushion carrier -2- using side cutters.
- 5.2.1. Disengage cushion clips -1- at the sides and unclip them at the underside if necessary.
- 5.3. Cut the cushion clips at the rear -1- using side cutters.
- 5.1. For seats with air conditioning:
- Remove tie-wraps, lines and connectors on the underside of the seat.
- 6.1. Cut the two tie-wraps -1 and 2- on the underside of the seat using side cutters.
- 6.2. Release connectors -3- (-A- ) and unplug them -B- .
- 6.3. Guide connectors -3- through towards the rear -C- .
- Remove cover from the padding.