Installing Gas-Discharge Headlight

→ Switch off ignition and remove ignition key.

→ Switch off the relevant loads when changing bulbs.

→ Only use bulbs listed in the bulb table.

→ Only install clean bulbs that are free of grease.

→ Always use a cloth or soft paper when working with bulbs.

→ Observe the safety instructions when changing a bulb in a Bi-Xenon headlight.

→ In certain states, it is compulsory to carry spare light bulbs.

Information 

• The work steps are described for the left rear door of the vehicle and must be performed in the same way on the other doors. Any different work steps are marked/highlighted. 

1. Plug in electric plug connection on the gas-discharge headlight. Check that it is seated securely.
   Fig 1: Connecting Gas-Discharge Headlight Electric Plug Connection

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Carefully fit the gas-discharge headlight into the bracket and lock it by turning once in direction of arrow.
   Fig 2: Turning To Fit Gas-Discharge Headlight Into Bracket

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Insert the cover into the tabs provided and close it until it engages securely.
   Fig 3: Closing Gas-Discharge Control Unit Cover

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.