Installation Instructions
WARNING:
Live components
- Risk of electric shock
→ Remove electric charge from component.
→ Make sure it does not switch on again.
→ Check that there is no electric charge
→ Cover adjacent live parts.
NOTE:
Incorrect handling of bulbs
- Risk of damage to bulbs and the bulb housing
→ Switch off ignition and remove ignition key.
→ Switch off the relevant loads when changing bulbs.
→ Only use bulbs listed in the bulb table.
→ Only install clean bulbs that are free of grease.
→ Always use a cloth or soft paper when working with bulbs.
→ Observe the safety instructions when changing a bulb in a Bi-Xenon headlight.
→ In certain states, it is compulsory to carry spare light bulbs.