Removing Spoiler Drive
WARNING:
Electrically moved components
- Danger of limbs being trapped or severed
→ Switch off electric power to drive motor.
→ Make sure it does not switch on again.
→ Check that there is no electric charge.
- Extend the spoiler -1- .
- Switch off ignition and remove remote control (hand-held transmitter).
- Affix adhesive tape -2- to protect the adjacent areas of the spoiler recess.
- Disconnect wire harness.
- 4.1. Release plug connection -3- (-a- ) and pull it off -B- .
- 4.2. Lever off retaining clip -4- for wire harness.
- 4.3. Disconnect the cable strap -5- and remove it from the lid.
- Unscrew fastening screws -6- .
- Screw off fastening nuts -7- .
- Swivel spoiler drive out towards the rear -arrow- and remove it.
- Loosen wire harness for rear spoiler at the left spoiler drive.
- 1.1. Unscrew fastening screw -1- and remove microswitch for rear spoiler -2- (-arrow A- ).
- 1.2. Unclip wire harness for rear spoiler -3- at the spoiler drive -arrow B- and remove it.
- Remove rear cover.
- 2.1. Press pin on expanding clip -2- through using a punch -arrow A- and take expanding clip -2- out of the rear cover -1- .
- 2.2. Release clip on rear cover -1- using a small screwdriver -arrow a- and pull it off the spoiler drive -arrow B- .
- Remove closing element of rear spoiler.
- 3.1. Mark installation position of closing element of rear spoiler -2- with respect to the two spoiler drives -3- .
- 3.2. Unscrew and remove fastening screws -1- on closing element of rear spoiler -2- on both sides -arrows A- .
- 3.3. Remove closing element of rear spoiler -2-
- -arrow B-
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove lower part of rear spoiler.
- 4.1. Mark installation position of lower part of rear spoiler -3- with respect to the two spoiler drives -4- .
- 4.2. Unscrew and remove fastening screws -1- on lower part of rear spoiler -3- on both sides and remove retaining brackets -2- (-arrow A- ).
- 4.3. Remove lower part of rear spoiler -3-
(-arrow B-
).
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Screw off fastening nuts -2- on the spoiler drive -1- .
- Remove threaded bolts -2- from the spoiler drive -1- (-arrows A- ) and remove the spoiler drive -1- (-arrow B- ).