Disconnecting Optical Waveguide

→ Remove the ignition key and switch off load before disconnecting or removing load.

Information 

Observe the general information on optical waveguides. General information on optical waveguides - MOST bus

Information 

Before routing a new optical waveguide:

• Visually check the locks, connector housing and contacts for damage. 
• Replace damaged parts if necessary. 

1. Release and unplug the optical waveguide connector -3-  from the loudspeaker booster. Pull off electric plug connections -4-  .
   Fig 1: Releasing Connector

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Release and unplug the optical waveguide connector -3-  from the PCM -arrow a-  (-arrow A-  ). Pull off electric plug connections -4, 5, 6, 7, 8-  .
   Fig 2: Unplugging Optical Waveguide From PCM

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Release and unplug the optical waveguide connector -3-  from the reversing camera control unit. Pull off electric plug connections -4-  .
   Fig 3: Unplugging Optical Waveguide From Reversing Camera Control Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.