LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Panamera 4 >> Repair and Diagnosis >> Collision >> Body Panels >> 53 - Body Rear - PANAMERA (970) >> WM 530555 Replacing Rear Closing Panel (Except PANAMERA S Executive, PANAMERA Executive, PANAMERA 4 S Executive, PANAMERA Turbo Executive, PANAMERA Turbo S, PANAMERA Turbo S Executive, PANAMERA GTS, PANAMERA 4S Sport Edition) >> Preparing Rear Closing Panel For Installation

Preparing Rear Closing Panel For Installation

  1. Fit closing panel and secure it to the body.

    Information 

    Do not drill a hole in the marked area.

    1. 1.1. Drill bores for the rivets through the existing holes. → Diameter: 6.5 mm 
      Fig 1: Identifying Closing Panel
      G09809789Courtesy of PORSCHE CARS NORTH AMERICA, INC.
      Fig 2: Fitting Closing Panel
      G09809790Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Remove closing panel.
    3. Fig 3: Removing Closing Panel
    G09809791Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Countersink bores for installing countersunk rivets. Countersink nr.202 
    Fig 4: Fitting Closing Panel
    G09809792Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    Fig 5: Identifying Closing Panel
    G09809793Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Prepare connection areas for bonding.
    Fig 6: Preparing Closing Panel
    G09809794Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals