Possible Separation Points

Information 

Cuts can be made in the defined areas in the outer side member due to the parts dimensions. The purpose of the different cuts is to keep the repair area as small as possible in the event of damage.

The diagram should help you to determine the correct position of cuts.

A-B-C  - Replace cuts for outer side member → 514555 REPLACING OUTER SIDE MEMBER 

B-C-  - Replace cuts for center side member → 514855 REPLACING 

D center side member 

B-C-D  - Replace cuts for B-pillar reinforcement → 514255 REPLACING B-PILLAR REINFORCEMENT 

E-F  - Replace cuts for B-pillar → 514155 REPLACING B-PILLAR 

Fig 1: Identifying Separation Points On Outer Side Member

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

D  - → Distance: 150 mm 

E  - → Distance: 330 mm 

F  - → Distance: 100 mm 

Fig 2: Identifying Separation Points On Outer Side Member

Courtesy of PORSCHE CARS NORTH AMERICA, INC.