Removing Sub-Part Of Front Left Wire Harness
- Remove carpet at the front left. →
- Release cable duct at the A-pillar.
- 2.1. Unscrew fastening nut -1- for cable duct.
- 2.2. Release cable duct -2- from the fixing clip by pulling it -arrow- .
- Release cable duct on driver's seat.
- 3.1. Unscrew fastening nut -1- on driver's seat.
- 3.2. Release cable duct by pulling it -arrow- off the fixing clip.
- Unclip and disconnect main wire harness at the front inner sill.
Information
When cutting the front wire harness, make sure there is enough length of cable left to join to the new lines.
- Cut front left wire harness in area -x- .
- Make sure that all fastenings on the front left wire harness in the interior are released.
- Loosen rubber sleeve in the left wheel housing, remove it by pushing it towards the wheel housing and carefully remove the wire harness from the interior by pushing it towards the wheel housing.
- Loosen sub-part of wire harness in the front left wheel housing at all 13 fastening points -A- and release and pull off all plug connections.
- Unscrew fastening nut -B- on ground point for left longitudinal member and pull lines off the threaded bolt.
- Loosen sub-part of wire harness in the front left wheel housing at the bottom at all six fastening points -A- and release and pull off all plug connections.
- Loosen sub-part of wire harness in the front left wheel housing at all 10 fastening points -A- and release and pull off all plug connections.
- Loosen sub-part of wire harness in the engine compartment at the left at all 10 fastening points -A- and release and pull off all plug connections.
- Disconnect connection at the B+ connection point in the engine compartment.
- 13.1. Unscrew left nut -1- and remove it -arrow A- .
- 13.2. Remove connection for fan blower -3- .
- Make sure that all fastenings on the wire harness in the engine compartment at the left are released.
- Carefully remove sub-part of front left wire harness from the engine compartment through the openings by pulling it towards the wheel housing.
- Make sure that all fastenings on the wire harness in the front left wheel housing are released.
- Remove entire sub-part of front left wire harness.