Removing Multi-Functional Switch

WARNING: This page is about a different variant/trim than selected.

WARNING: If the supports are folded down, the vehicle will roll off the platform lift when it is lowered.

→ Ensure that the platform is prevented from lowering.

→ Remove supports before lowering.

Lever selector cable off the ball pin and disengage from support bracket.

Fig 1: Locating Selector Lever And Cable
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Place transmission jack under the transmission.
Unscrew fastening screws between the transmission and the transmission support.

Fig 2: Locating Transmission And Transmission Support Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

The fastening nuts of the transmission support must never be loosened at the hydraulic mount because otherwise the transmission brackets will be damaged.
Unscrew fastening screws between the body and the hydraulic mount -arrows- .
1. Transmission support
2. Hydraulic mount
3. Fastening nut (never loosen)
  
  Fig 3: Locating Transmission Support, Hydraulic Mount And Fastening Nuts
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect the plug connection for the multi-function switch.

Fig 4: Identifying Multi-Function Switch Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew fastening screws between multi-functional switch and transmission and pull off multi-functional switch from selector lever.

Fig 5: Locating Multi-Functional Switch Fastening Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.