Installing Selector Support

Before starting to install the selector support, ensure that the transmission and selector support are in position "P".

1. Install selector support.

   Fit the selector support -1-  and screw on and tighten nuts -2-  .

   → Tightening torque: 10 Nm (7.5 ftlb.) 

   Fig 1: Identifying Selector Support And Nuts

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Connect selector support.
   1. 2.1. Insert parking lock cable into the bayonet lock -2-  and lock the bayonet lock.
   2. 2.2. Attach parking lock cable to the support and engage securely.
   3. 2.3. Connect electric multiple plug connector -3-  .
   Fig 2: Connecting Selector Support

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.