Refitting Transmission
WARNING: This page is about a different variant/trim than selected.
Information
Before installing the transmission, clean splines of transmission input shaft and grease lightly, e.g. with Olista Longtime 3 EP.
- Move transmission into position and screw in fastening screws -1 to 8-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Location Description Type Basic value Tolerance 1 Tolerance 2 Transmission/engine connection Hexagon-head bolt no. 1 in figure, M12 x 70 Tightening torque 85 Nm (63 ftlb.) Transmission/engine connection Hexagon-head bolt no. 2 in figure M12 x 100; with washer Tightening torque 85 Nm (63 ftlb.) Transmission/engine connection Hexagon-head bolt no. 3 in figure, M12 x 100 Tightening torque 85 Nm (63 ftlb.) Transmission/engine connection Internal-serration screw no. 4 in figure M10 x 40 Tightening torque 45 Nm (33 ftlb.) Transmission/engine connection Hexagon-head bolt no. 5 in figure M12 x 70 Tightening torque 85 Nm (63 ftlb.) Transmission/engine connection Nut no. 6 in figure M10 Tightening torque 45 Nm (33 ftlb.) Transmission/engine connection Hexagon-head bolt no. 7 in figure M12 x 90 Tightening torque 85 Nm (63 ftlb.) Transmission/engine connection Hexagon-head bolt no. 8 in figure M12 x 90 Tightening torque 85 Nm (63 ftlb.)