Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Transmission/engine connection | Hexagon-head bolt no. 1 in figure, M12 x 70 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Transmission/engine connection | Hexagon-head bolt no. 2 in figure M12 x 100; with washer | Tightening torque | 85 Nm (63 ftlb.) | ||
| Transmission/engine connection | Hexagon-head bolt no. 3 in figure, M12 x 100 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Transmission/engine connection | Internal-serration screw no. 4 in figure M10 x 40 | Tightening torque | 45 Nm (33 ftlb.) | ||
| Transmission/engine connection | Hexagon-head bolt no. 5 in figure M12 x 70 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Transmission/engine connection | Nut no. 6 in figure M10 | Tightening torque | 45 Nm (33 ftlb.) | ||
| Transmission/engine connection | Hexagon-head bolt no. 7 in figure M12 x 90 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Transmission/engine connection | Hexagon-head bolt no. 8 in figure M12 x 90 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Clutch slave cylinder | Fastening screws between transmission housing and clutch slave cylinder | Tightening torque | 23 Nm (17 ftlb.) | ||
| External shift mechanism | Fastening nut between shifting shaft and external shifting mechanism | Tightening torque | 23 Nm (17 ftlb.) | ||
| Transmission support | Fastening screws between transmission support and transmission | Tightening torque | 65 Nm (48 ftlb.) | ||
| Hydraulic mount | Fastening screws between hydraulic mount and body | Tightening torque | 33 Nm (24 ftlb.) | ||
| Cross member | Fastening screws between cross member and body | Tightening torque | 65 Nm (48 ftlb.) | ||
| Drive shafts | Fastening screws between drive shaft and transmission flange | Tightening torque | 60 ftlb. | ||
| Anti-roll bar | Fastening screws between anti-roll bar and rear axle carrier side member | Tightening torque | 17 ftlb. | ||
| Restraining cable | Fastening nut between restraining cable and cross member | Tightening torque | 23 Nm (17 ftlb.) |