Removing Gearshift Bracket

WARNING: This page is about a different variant/trim than selected.

Locking bridge 9619/1 must be fitted on the gearshift bracket.

Fig 1: Fitting Locking Bridge
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Open bayonet locks on the pre-selector and shifting connections.

Fig 2: Opening Bayonet Lock
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disengage adjustment pin on pre-selector and shifting connections.

Fig 3: Disengaging Shift Cables
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unclip supports on the gearshift bracket.

Fig 4: Removing Gearshift Bracket Supports
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew nut and lift gearshift bracket up and off.

Fig 5: Removing Gearshift Bracket
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove locking bridge.

Fig 6: Removing Locking Bridge
Courtesy of PORSCHE CARS NORTH AMERICA, INC.