Installing Spring Strut

Information 

• Always check the parts visually before installation. 
• Replace brake calliper fastening screws. 
• Do not grease screwed connections in Dacromet finish - aluminum color! 
• Observe correct tightening torques. 

1. Install in reverse order.
2. Insert spring strut into vehicle. Before tightening the fastening nuts, adjust spring strut mount in accordance with the applied marking (position of the three fastening nuts).

   Then double-check that the support ring is still positioned correctly on the spring strut mount → Fig 1 . The cut-outs in the support ring must be positioned between the collars of the three fastening bolts -Arrows-  . Re-establish the correct position if necessary.

   Fig 1: Locating Support Ring

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Insert parking-brake cable into the deflector box and into the clip at the rear wall.
4. Engage brake cable sideways into the turnbuckle → INSTALLING BRAKE CABLES . Fit floor in oddments tray of the center console.

   The handbrake does not have to be adjusted (self-adjusting).

   Fig 2: Removing Parking-Brake Cable

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Fit brake calliper and holder for brake line/brake hose at the wheel carrier.
6. Connect and clip in all electric plugs.