Installing ATF Pan

Clean all magnets in the seams of the ATF pan. Make sure to stick the magnets back on fully.
Fit ATF pan with new gasket -1- . When doing this, check that all spacer sleeves -2- are inserted fully in the new gasket.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

ATF-pan seal
Tighten screws on the ATF pan in several steps and in diagonally opposite sequence. > Tightening torque 8 (6 ftlb.) Nm --
Install overflow pipe -C- . > Tightening torque 2 Nm --
Screw in oil drain plug -A- with a new sealing ring -B- . > Tightening torque 20 (15 ftlb.) Nm --

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Overflow pipe on ATF pan