Calibration After Completion Of Vehicle Measurement Work

Perform the required calibrations, depending on vehicle equipment, if the previous wheel alignment values (on rear and/or front axle) were changed: 

1. Calibrate steering angle sensors.

   > WM, 456005 INITIALISING AND CALIBRATING STEERING-ANGLE SENSOR

2. Calibrate control unit for distance measuring sensor (ACC sensor).

   > WM, 278515 ADJUSTING DISTANCE MEASURING SENSOR CONTROL UNIT

3. Calibrate front camera.

   > WM 963825 PROGRAMMING FRONT CAMERA (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))