Removing And Installing Rear Body Acceleration Sensor

The rear body acceleration sensor (item 7) is integrated into the levelling system/PASM control unit (item 6).

1. Remove rear side trim panel at the right.

   > WM 700319 REMOVING AND INSTALLING SIDE TRIM PANEL FOR REAR LUGGAGE COMPARTMENT (EXCEPT CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))

2. Remove levelling system/PASM control unit.

   > WM, 431619 REMOVING AND INSTALLING PASM CONTROL UNIT 

   Installation is performed in reverse order.