Subsequent Work (Pdcc)
Information
- The reservoir is located at the front left of the engine compartment.
- A dipstick with MIN/MAX markings is mounted on the cap of the reservoir. These markings are for a fluid level on a cold engine (approx. 20°C).
- The MAX marking can be easily exceeded at higher temperatures.
- Check the fluid level (Pentosin CHF 11 S) with the engine switched off and cold (approx. 20°C).
- Install left air cleaner housing.
- Fit front left wheel.
- Install intake manifold at the left.
> Refer to the appropriate service information
- Install pressure pipe at the left.
> Refer to the appropriate service information
- Install front trim panel (engine compartment) at the left.
- Fill the reservoir and do not exceed the MAX marking.
- Bleed the PDCC and hydraulic power assistance system.