Technical Values
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| No. 3: Threaded connection securing steering column to assembly bracket | M8 x 32 thread; Observe specified tightening sequence! Starting with the rear right fastening screw, tighten 1- 4 anti-clockwise. | Tightening torque | 20 (15 ftlb.) Nm | ||
| No. 4: Threaded connection securing steering column to frequency strut | M8 x 115 thread; screw frequency strut to mounting bracket after screwing on steering column! | Tightening torque | 20 (15 ftlb.) Nm | ||
| No. 5: Threaded connection securing mount for sealing ring/sealing sleeve to firewall | Tightening torque | 4 (3 ftlb.) Nm | |||
| No. 6: Threaded connection securing universal joint to steering gear | M8 x 30 thread (only use screw once) | Initial tightening | 20 (15 ftlb.) Nm | ||
| No. 6: Threaded connection securing universal joint to steering gear | M8 x 30 thread (only use screw once) | Final tightening | + 90° | ||
| Threaded connection for heat shield | Item 4: M6 x 16 thread | Tightening torque | 9 (6.5 ftlb.) Nm | ||
| Knee airbag holder to mounting bracket | Tightening torque | 8 (6 ftlb.) Nm |