Installing Rear Brake Calliper
WARNING: This page is about a different variant/trim than selected.
WARNING:
Old mounting parts fitted on the brake calliper
- Reduced braking effect
- Risk of damage to the brake calliper
- Fit new fastening screws
The brake calliper is installed in reverse order.
Information
- Replace screws.
- Never use an impact bolter to loosen and tighten the brake calliper on the wheel carrier.
- Observe correct tightening torques
> 4X00IN TIGHTENING TORQUES FOR BRAKE HYDRAULICS
- Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
- Fit the brake calliper.
Information
- Make sure that the brake line is not twisted. A twisted brake line can damage the bellows at the drive shaft while driving.
- Fit the brake line to the brake calliper.
- Fit the holder for the brake pad wear indicator cable and for the brake line to the brake calliper.
- Clip in the connector for the brake pad wear indicator.
- Position disc brake pads by operating the brake several times.