Subsequent Work For Removing And Installing Spreader Device (Epb)
WARNING: This page is about a different variant/trim than selected.
- Install brake shoes.
> 468356 Replacing brake shoes - section on "INSTALLING "
- Fit the brake calliper.
> 474119 Removing and installing rear brake calliper - section on "INSTALLING "
Information
If new brake discs and/or new brake shoes are installed on the vehicle, they must be worn in before calibration (not PCCB!).
> WM, 468350 GRINDING DOWN PARKING-BRAKE SHOES (EPB)
If a new actuator was installed, it must be confirmed in the Porsche System Tester.
- >>Control unit overview<<>>Parking brake<<>>Drive links/Tests<<>>Confirm actuator replacement<<.
- Adjust and calibrate the parking-brake shoes.
>468316 ADJUSTING AND CALIBRATING PARKING-BRAKE SHOES
Grind down the parking-brake shoes during adjustment and calibration if necessary.