Removing Control Unit For Parking Brake

WARNING: This page is about a different variant/trim than selected.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position of control unit for parking brake

Information

Always comply with the regulations for handling ESD-sensitive components!

Always wear approved work clothes and shoes when carrying out assembly work.
Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation.
Do not touch electric pins and plug contacts.

NOTE: NOTIFICATION
Voltage peaks

Risk of damage to electrical load or to the control unit
1. Remove the ignition key and switch off load before disconnecting or removing load.

Unscrew the two fastening screws -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting point for control unit for parking brake
Release the plug connection -a- and pull it off -A- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Disconnecting plug connection