Installing Front Brake Disc (Pccb)

Information 

• Always replace the brake calliper fastening screws following removal! 

Do not confuse right and left brake discs during assembly!

1. Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
2. Clean the levelling and centering surfaces on the brake disc and wheel hub.
3. Apply a very thin coat of Optimoly TA to the centering surface on the wheel hub.
4. Installation is performed in reverse order.

   Observe specified tightening torques:

   Brake disc to wheel hub: > Tightening torque 15 (11 ftlb.) Nm 

   Brake calliper to wheel bearing housing: > Tightening torque 140 Nm (104 ftlb.) 

   Brake hose bracket to wheel carrier: > Tightening torque 20 (15 ftlb.) Nm 

   Cable holder to wheel carrier: > Tightening torque 9 (6.5 ftlb.) Nm