Installing Mounting Saddle

WARNING: This page is about a different variant/trim than selected.

Fit mounting saddle in the vehicle.
Fit fastening screw -1- at the bottom.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening screw for mounting saddle at the bottom
Fit fastening screws -1- for the heat shield -2- at the left of the longitudinal member.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Heat shield, left
Fit the fastening screw -1- for the mounting saddle at the left under the brake booster.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening screw for mounting saddle in plenum panel at the bottom
Fit the top fastening screws -1- for the mounting saddle in the plenum panel.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening screws for mounting saddle at the top
Pre-fit tie-wraps -1- in the cable duct -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pre-fitting tie-wraps in cable duct
Clip in fixing clips -1- from the cable duct -2- at the mounting saddle.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Clips on cable duct
Secure main wire harness in the cable duct using the tie-wraps and then clip on the cable duct cover.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Main wire harness in cable duct
Secure main wire harness on cable duct.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Main wire harness at the side of the cable duct
Fit the fastening nuts -1- for the brake booster under the dashboard.
> 4X00IN TIGHTENING TORQUES FOR BRAKE MECHANISM

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fitting brake booster
Fit the relay carrier.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fit relay carrier at the right
1. 11.1 Insert the guide -3- for the relay carrier at the right next to the brake pedal from above -B- and into the holder -4- .
2. 11.2 Press the relay carrier -2- down into the guide -A- .
3. 11.3 Fit the fastening screw -1- .