LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 48 (42 - Rear Wheel Suspension Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 425855 Replacing Rear Wheel Bearing >> Preliminary Work >> Preliminary Work For Replacing Rear Wheel Bearing

Preliminary Work For Replacing Rear Wheel Bearing

WARNING: This page is about a different variant/trim than selected.
WARNING: Mechanical, hydraulic or pneumatic press 
  • Risk of squashing 
    1. Read specific safety information for the press.
    2. Check that the press is working perfectly before use, particularly the safety components.

Information 

Do not raise the wheel suspension higher than the normal vehicle position. When raising the suspension, use a suitable intermediate layer made of hard rubber. Do not move the vehicle if drive shafts have not been fitted and tightened.

Information 

Use a tie-wrap to prevent the shoe mounts on the actuator of the electric parking brake (referred to below as EPB) from twisting.

  1. Remove the corresponding hub cap with > 9229/1 - puller hook and release the axle nut (lock nut) before lifting the vehicle. Operate the brake whist doing so (2 fitters required).
  2. Remove wheel.

    > 440519 Removing and installing wheel - section on "REMOVING "

  3. Remove the wheel bearing housing.

    > 425219 REMOVING AND INSTALLING WHEEL BEARING HOUSING  - section on "Removing"

    and set it down.

scientia non olet · About LEMON Manuals