Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| No. 1: Threading connection securing drive shaft to wheel hub (1st step) | This is done before installing the wheel bearing housing/M24 x 1.5 thread/Always replace lock nut after removal | Tightening torque | 130 Nm (95.9 ftlb.) | ||
| Pressing out drive shaft | -Max.- | Length | 10 mm | + 5 mm |