Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Adjust the brake shoes to their basic setting and calibrate the electric parking brake actuators.
- Connect the level sensor to the front upper wishbone.
> 431955 Replacing rear level sensor - section on "INSTALLING "
Make sure that the level sensor linkage is facing outwards.
- Fit the wheel.
> 440519 Removing and installing wheel - section on "INSTALLING "
- Tighten axle nut (drive shaft mounting on wheel side) (2-step tightening procedure!). Operate the brake while doing this (2 mechanics required).
- For vehicles with air suspension:
Fill the air springs.
- Perform suspension alignment.
> Suspension alignment, complete