General Overview
WARNING: This page is about a different variant/trim than selected.
Information
- The tightening steps in the tightening sequences relate to tightening screws uniformly, i.e. all affected screws must first be tightened uniformly to the first torque value, then all screws are tightened one stage further, and so on.
- Replace all 0-rings following removal!
The torques in the table below generally apply to screws that are not specifically listed =>
The bolt quality is indicated on the screw head at the top as a decimal number, e.g. "8.8" or "12.9".
TIGHTENING TORQUE SPECIFICATIONSBolt quality 8.8 Bolt quality 10.9 Bolt quality 12.9 Thread [Nm (ftlb.)] Thread [Nm (ftlb.)] Thread [Nm (ftlb.)] M4 3 (2) M4 4 (3) M4 5 (3.5) M5 6 (4.5) M5 8 (6) M5 10 (7.5) M6 10 (7.5) M6 13 (9.5) M6 16 (12) M8 23 (17) M8 33 (24) M8 39 (29) M10 45 (33) M10 65 (48) M10 80 (59) M10 x 1.25 50 (37) M10 x 1.25 70 (52) M10 x 1.25 85 (63) M12 80 (59) M12 115 (85) M12 135 (100) M12 x 1.25 90 (67) M12 x 1.25 125 (93) M12 x 1.25 150 (111) M12 x 1.5 85 (63) M12 x 1.5 120 (89) M12 x 1.5 145 (107) M14 130 (96) M14 180(133) M14 220 (163) M16 200 (148) M16 280 (207) M16 335 (248)