Torque Loss
WARNING: This page is about a different variant/trim than selected.
Necessary after:
- Re-programming DME control unit
- Replacing DME control unit
- Re-programming PDK control unit
Necessary before:
- Re-calibrating PDK
How?
Engine idling
- Preconditions:
- 1.1 Engine at operating temperature
- Engine idling for 3 minutes without activating loads, press accelerator pedal once after approx. 1.5 minutes during this time
- Engine idling for 3 minutes with air conditioning switched on, press accelerator pedal once after approx. 1.5 minutes during this time
- Engine idling for 3 minutes with air conditioning switched on and transmission range engaged, press accelerator pedal once after approx. 1.5 minutes during this time
- Switch off ignition (see also Information)