Installing Air Cleaner Housing

WARNING: This page is about a different variant/trim than selected.

Insert the air cleaner housing into the engine compartment at an angle from above. > Air cleaner housing

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Air cleaner housing
Guide the two retaining bolts on the underside into the take-up bores in the body -arrows- . From the wheel housing, check to make sure that the blue rubber washers are present and make sure that the bolts are fitted properly.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening bolts and rubber washers
Tighten the fastening screw -arrow- on the air cleaner housing. > Tightening torque 10 (7.5 ftlb.) Nm -- dang --

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening screw
Insert air-cleaner element.
> 242455 Replacing air-cleaner element - "REPLACING "
Fit the cover -1- of the air-cleaner box using the side guides -2- on the air cleaner housing -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fitting air cleaner cover
1. 5.1 Slide the cover down -A- .
2. 5.2 The guides -4- on the cover must fit into the mountings -5- on the air cleaner housing.
Fold the cover -1- up towards the air cleaner housing -2- (-A- ).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installing air cleaner cover
Clip in the two upper fastening clamps -arrows- on the air cleaner housing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fasting clamps
Slide the intake port into the cover of the air cleaner housing.
Push the bolts fully into the mountings and turn them 180° > Securing connections on air cleaner .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Securing connections on air cleaner
Insert the air guide into the air cleaner housing.
> 242519 Removing and installing air cleaner housing - "INSTALLING "