Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Disconnect tool and reconnect vehicle connections. Absorb and wipe off residual fuel with a cloth.
Fuel supply and connection points at right connection unit
- Fit the right cap (figure shows both caps). Then tighten the four fastening nuts on each to > Tightening torque 10 (7.5 ftlb.) Nm
. Refit carpeted floor and fix in place with double-sided adhesive tape.
Fastening nuts on caps
- Install rear seat.
- Close the filler flap.
- Air the vehicle with the windows open.