Removing Rear Spring Strut (Steel Springs With PASM)
WARNING:
Wheel bearing housing raised incorrectly
- Risk of squashing
- Risk of damage to components
→ Wear personal protective gear.
→ Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
Information
- Spring strut screws are tensioned. Use a suitable lift with rubber base .
Information
- The pictures shown in this document may differ from the original .
- Remove caps -1- from the top screws on the spring strut at the front, under the side panel of the luggage compartment cover, using a suitable tool.
- Loosen fastening screws -1- on the upper spring strut, but do not remove them.
- Raise the vehicle. → 4X00IN LIFTING THE VEHICLE
- Release electric plug connection at the upper spring-strut mount -1- (-a- ) and disconnect it -A- .
- Secure the spring strut using a suitable jack → Lifting wheel bearing housing (example) .
- Remove the lower spring strut -1- from the wheel bearing housing -2- and connecting link -4- . To do this, loosen fastening screw -3- .
- Remove the jack and carefully lever the spring strut -1- out of the wheel bearing housing -2- using a suitable tool, e.g. mounting lever.
- Lower the vehicle.
- A second mechanic is needed to hold and remove the spring strut
.
The first mechanic unscrews the top fastening screws -1- on the spring strut completely.
The second mechanic holds the spring strut securely and then pulls it out of the vehicle.