Technical Values
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des.. | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| No. 2: Threading securing tie rod to chassis subframe | M14 x 1.5 thread (always replace bolts and lock nuts after removal) | Tightening torque | 170 Nm (125.4 ftlb.) | ||
| No. 3: Threading securing tie rod to wheel carrier | M16 x 1.5 thread (always replace bolts and lock nuts after removal) | Initial tightening | 150 Nm (110.6 ftlb.) | ||
| No. 3: Threading securing tie rod to wheel carrier | M16 x 1.5 thread (always replace bolts and lock nuts after removal) | Final tightening | + 90° |