Technical Values
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Actual dimension | Displayed on the Tester! Actual gap dimension at left and right measured between the shoe and drum in millimeters. | Control value | 000 mm | ||
| Required dimension | Displayed on the Tester! Required dimension between the shoe and drum in millimeters. | Control value | + 2.2 mm | +/- 0.3 mm | |
| Adjustment dimension | Must be calculated! Value (in millimeters) by which the adjustment device must be turned. | Control value | 000 mm | ||
| Adjustment device | 1 click corresponds to | Control value | 0.15 mm |