Technical Values

TIGHTENING TORQUE SPECIFICATIONS

Location	Des...	Type	Basic val...
Primary catalytic converter to exhaust manifold	M8 lock nuts/Always replace nuts following removal	Tightening torque	23 (17 ftlb.) Nm
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Threaded joint for primary catalytic converter
Primary catalytic converter to holder	M8 screw	Tightening torque	23 (17 ftlb.) Nm
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Left primary catalytic converter holder
Catalytic converter to transfer gear holder	M8 screw	Tightening torque	23 (17 ftlb.) Nm
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Catalytic converter holders
Minimum installation dimension for torque converter	Cayenne S/GTS/Turbo -check that it is seated correctly and prevent it from tilting	Control value (minimum dimension)	4.5 mm
Torque converter to drive plate	Screw, M10x 1 -replace	Tightening torque	85 (63 ftlb.) Nm
Fastening screw securing transmission to engine	Aluminium screw, M12 x 70	Final tightening torque angle	90 Grad
Fastening screw securing transmission to engine		Final tightening	+ 90 Grad
Fastening screw securing transmission to engine	Aluminium screws, M12 x 70 - replace screws	Initial tightening	38 (28 ftlb.) Nm
Fastening screw securing ATF line to heat exchanger		Tightening torque	8 (6 ftlb.) Nm
Fastening screw securing ATF line to transmission		Tightening torque	20 (15 ftlb.) Nm
Fastening screw securing ATF line to transmission		Tightening torque	20 (15 ftlb.) Nm
Heat shield to automatic transmission	Screw, M6/Item 1	Tightening torque	15 (11 ftlb.) Nm
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Heat shield for automatic transmission
Screw transmission bracket to transmission mount	Replace	Initial tightening	50 Nm (36.9 ftlb.)
Screw transmission bracket on transmission mount		final tightening	90 Degree
Holder for coolant lines to transmission	M6 screws/Item 1	Tightening torque	10 (7.5 ftlb.) Nm
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Coolant line holders