Adjusting Multi-Functional Switch

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Overview of multi-functional switch

1. Move selector lever to position N.
2. Remove heat shield on the transmission. To do this, unscrew three fastening screws -arrow-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Heat shield to right side of transmission

3. Disconnect cable on multi-functional switch.
4. Remove cap nut, cap, nut with tab washer and rubber washer on the multi-functional switch.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Assembling multi-functional switch

5. Loosen fastening screws -arrow-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Fastening screws for multi-functional switch

6. Push special tool > T10173 - setting gauge  onto the shaft and secure it to the shaft with a screw -arrow-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Adjusting tool on multi-functional switch

7. Screw in fastening screws -arrow-  and remove special tool. > Tightening torque 5 (3.5 ftlb.) Nm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Fastening screws for multi-functional switch

8. Install cap nut, cap, nut with tab washer and rubber washer on the multi-functional switch.

   Tighten nut.

   > Tightening torque 7 (5 ftlb.) Nm

   Tighten cap nut.

   > Tightening torque 15 (11 ftlb.) Nm

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Assembling multi-functional switch

9. Connect compact connector to multi-functional switch.
10. Install heat shield on the transmission. To do this, screw in three fastening screws -arrow-  .

    > Tightening torque 10 (7.5 ftlb.) Nm

    Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Heat shield to right side of transmission