Component Overview
Air-spring strut, complete
Exploded view of air-spring strut
| No. | Designation | Note |
|---|---|---|
| -1- | Connector housing | Only for PASM (Porsche Active Suspension Management) |
| -2- | Grommet (connector) | Only for PASM |
| -3- | Grommet (cable) | Only for PASM |
| -4- | Cable guide | Only for PASM |
| -5- | Hexagon nut (4x) | Use new hexagon nuts. |
| -6- | Cover | Refer to the Parts Information for details of allocation. |
| -7- | Cable holder (rubber) | Only for PASM |
| -8- | Shock absorber mounting | Refer to the Parts Information for details of shock absorber mounting allocation. |
| -9- | Ring, small (O-ring) | Please use a new sealing ring. |
| -10- | Hexagon nut | Please use a new lock nut. |
| -11- | Pressure control valve with sealing ring | Please use a new sealing ring. |
| -12- | Push-on connector | |
| -13- | Air spring | |
| -14- | Boot/bellows | Please use a new boot/bellows. |
| -15- | Ring, large (O-ring) | Please use a new seal. |
| -16- | Shock absorbers | Refer to the Parts Information for details of allocation. |
| Safety catch | Always replace safety catch (shown fitted on shock absorber!) | |
Cut-out view of air-spring strut on rear axle
| 1 | Cover |
| 2 | Shock absorber mounting |
| 3 | Air spring |
| 4 | Additional spring |
| 5 | Retainer |
| 6 | Clamping ring |
| 7 | Air-spring bellows |
| 8 | Outer guide |
| 9 | Rolling piston |
| 10 | Boot/bellows |
| 11 | Ring, large (O-ring) |