Installing Rear Brake Disc (Pccb)
WARNING: This page is about a different variant/trim than selected.
Information
- Brake calliper screws can always be re-used if no damage can be identified.
- Replace damaged bolts.
- Observe different tightening specifications!
Do not confuse right and left brake discs during assembly!
- Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
- Clean the levelling and centring surfaces on the brake disc and wheel hub.
- Apply a very thin coat of Optimoly TA to the centring surface on the wheel hub.
- Installation is performed in reverse order
Observe specified tightening torques:
Brake disc to wheel hub: > Tightening torque 15 (11 ftlb.) Nm
Brake calliper to wheel bearing housing: > Tightening torque 85 Nm (63 ftlb.)
Cable holder to wheel bearing housing: > Tightening torque 8 (6 ftlb.) Nm
- Connect and start the Porsche System Tester.
- 5.1 Adjust and calibrate the parking-brake shoes.
- Position disc brake pads by operating the brake several times.
- Check the brake fluid level and correct it if necessary.