Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| No. 7: Fastening screw securing brake disc to wheel hub | M12 x 1.5 thread (always replace screws and lock nuts after removal) | Tightening torque | 15 (11 ftlb.) Nm | ||
| No. 10: ABS cable holder to rear-axle wheel carrier | M6 x 12 thread | Tightening torque | 8 (6 ftlb.) Nm | ||
| Threaded connection securing brake calliper to rear-axle wheel carrier HA | M12 x 1.5 x 115 thread (always replace screws and lock nuts after removal) | Tightening torque | 85 Nm (63 ftlb.) |