Installing Front Brake Disc
WARNING: This page is about a different variant/trim than selected.
Information
- Always replace the brake calliper fastening screws following removal!
Do not confuse right and left brake discs during assembly!
- Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
- Clean the levelling and centring surfaces on the brake disc and wheel hub.
- Apply a very thin coat of Optimoly TA to the centring surface on the wheel hub.
- Installation is performed in reverse order.
Observe specified tightening torques:
Brake disc to wheel hub: > Tightening torque 15 (11 ftlb.) Nm
Brake calliper to wheel bearing housing (18-inch brakes): > Tightening torque 140 Nm (104 ftlb.)
Brake calliper to wheel bearing housing (19-inch brakes): > Tightening torque 140 Nm (104 ftlb.)
Brake hose bracket to wheel bearing housing: > Tightening torque 20 (15 ftlb.) Nm
Cable holder to wheel bearing housing: > Tightening torque 9 (6.5 ftlb.) Nm