LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 48 (46 - Brakes - Brake Mechanism (4.8L Turbo) -- 92A - Cayenne (92A)) >> WM, 461019 Removing And Installing Mounting Saddle >> Installing Mounting Saddle

Installing Mounting Saddle

WARNING: This page is about a different variant/trim than selected.
  1. Fit mounting saddle in the vehicle.
  2. Tighten fastening screws -1-  at the bottom. > Tightening torque 23 (17 ftlb.) Nm +/- 3 (2 ftlb.) Nm 
    G16319001Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screw for mounting saddle at the bottom

  3. Tighten fastening screws -1-  for the heat shield -2-  at the left of the longitudinal member. > Tightening torque 2 (1.5 ftlb.) Nm 
    G16319002Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Heat shield, left

  4. Tighten fastening screw -1-  for the mounting saddle at the left under the brake booster. > Tightening torque 23 (17 ftlb.) Nm +/- 3 (2 ftlb.) Nm 
    G16319003Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screw for mounting saddle in plenum panel at the bottom

  5. Tighten the top fastening screws -1-  for the mounting saddle in the plenum panel. > Tightening torque 23 (17 ftlb.) Nm +/- 3 (2 ftlb.) Nm 
    G16319004Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screws for mounting saddle at the top

  6. Pre-fit tie-wraps -1-  in the cable duct -2-  .
    G16319005Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Pre-fitting tie-wraps in cable duct

  7. Clip in fixing clips -1-  from the cable duct -2-  at the mounting saddle.
    G16319006Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Clips on cable duct

  8. Secure main wire harness in the cable duct and clip in cover.
    G16319007Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Main wire harness in cable duct

  9. Secure main wire harness on the cable duct.
    G16319008Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Main wire harness on cable duct

  10. Tighten the fastening nuts -1-  for the brake booster under the dashboard. > Tightening torque 26 Nm (19 ftlb.) +/- 3 Nm (2 ftlb.) 
    G16319009Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fitting brake booster

  11. Fit the relay carrier.
    G16319010Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fitting relay carrier at the right

    1. 11.1 Insert the guide -3-  for the relay carrier at the right next to the brake pedal from above -B-  and into the holder -4-  .
    2. 11.2 Press the relay carrier -2-  down into the guide -A-  .
    3. 11.3 Fit fastening screw -1-  .
scientia non olet · About LEMON Manuals