Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des.. | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| No. 2: Threaded connection securing anti-roll bar to suspension/stabiliser | M12 x 1.5 thread (always replace screws and lock nuts after removal) | Tightening torque | 100 (74 ftlb.) Nm | ||
| Threaded connection securing suspension/stabiliser to wheel carrier/shock absorber strut | M12 x 1.5 thread (always replace screws and lock nuts after removal) | Initial tightening | 90 (67 ftlb.) Nm | ||
| Threaded connection securing suspension/stabiliser to wheel carrier/shock absorber strut | M12 x 1.5 thread (always replace screws and lock nuts after removal) | Final tightening | + 90° |