Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des.. | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| No. 1: Threaded connection securing anti-roll bar to rear-axle chassis subframe | M10 x 30 thread | Tightening torque | 50 (37 ftlb.) Nm | ||
| No. 2: Threaded connection securing anti-roll bar to suspension/stabiliser | M12 x 1.5 thread (always replace screws and lock nuts after removal) | Tightening torque | 100 (74 ftlb.) Nm | ||
| Rear anti-roll bar | Distance between anti-roll bar and lower edge of longitudinal member in normal vehicle position | Control value | 96 mm |