Technical Values
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| No. 9: Wheel bearing housing to wheel carrier | M12 x 1.25 thread (always replace screws and lock nuts alter removal) | Initial tightening | 80 (59 ftlb.) Nm | ||
| No. 9: Wheel bearing housing to wheel carrier | M12 x 1.25 thread (always replace screws and lock nuts alter removal) | Final tightening | + 120° |