Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Apply the basic setting for the brake shoes and calibrate actuators for the electric parking brake.
- Connect the level sensor to the front upper wishbone.
Make sure that the level sensor linkage is pointing outwards.
> 431955 REPLACE REAR LEVEL SENSOR - section on "Installing"
- Fit wheel.
> 440519 REMOVE AND INSTALL WHEEL - section on "Installing"
- Tighten axle nut on drive shaft (Step 2). Activate the brake while doing this (helper required).
> Tightening torque 460 Nm (339.3 ftlb.) --
- For vehicles with air suspension- Fill air springs.
- Perform vehicle measurement.
> Vehicle measurement complete