Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Apply the basic setting for the brake shoes and calibrate the actuators for the el electric parking brake.
- Connect the level sensor to the front upper wishbone.
> 431955 Replacing rear level sensor - section on "INSTALLING "
Make sure that the level sensor linkage is facing outwards.
- Fit wheel.
> 440519 Removing and installing wheel - section on "INSTALLING "
- Tighten axle nut (drive shaft mounting on wheel side) (Step 2!). Operate the brake while doing this (2 mechanics required). > Tightening torque 460 Nm (339.3 ftlb.) --
- For vehicles with air suspension:
Fill the air springs.
- Perform suspension alignment.
> Refer to the appropriate service information.